CCTV IP Camera Default Usernames, Passwords and IP Addresses Setting

  Acti

Username: Admin/admin
Password: 12345/123456
IP address: 192. 168.0.100

Arecont Vision
Arecont does not have a default password , but you can reset it to factory settings. Follow these steps
1-Access the camera's web interface by typing the IP in your web browser.
2-Under the Administration or System tab, click on Restore to Factory Default.
3-Once the camera reboots, all settings on the camera will be restored to factory default

AXIS
For an old system:
Username: Root
Password: Pass
IP Address: 192.168.0.90
But new generation AXIS cameras have a resetting sequence
1-Remove the Ethernet cable
2-Press and hold the control button and insert the Ethernet cable again while holding the control button.
3-Hold the control button until the amber lights turn on.
4-Then release the button .
5-Wait about 1 minute.
6-When the amber lights turns into the green lights your camera is resetted and your passoword as well

BOSCH
For old models:
Username: service
Password: service
IP Address: 192.168.0.1
For new models:
You can reset the camera by pushing the reset button about 7 seconds. Or you can reset the NVR by removing the battery on the mainboard (not recommended, at your own risk)

DAHUA
Username: admin
Password: admin

GEOVISION
Username: admin
Password: admin
IP Address: 192.168.1.108

HIKVISION
For old models (before firmware 5.3.0)
Username: admin
Password: 12345
IP Address: 192.0.0.64
For new models you can reset password via SADP tool. Please click the link below and follow the instructions on the pdf file
Hikvision password resetting guide

LTS Security
Username: admin
Password: 12345 or123456
IP Address: 192.0.0.64
For platinum models please click the link below for pdf file.
LTS platinum series password reset

Messoa
Username: admin
Password: 1234 or model number of camera or
IP address: 192.168.1.30
Mobotix:
Username: admin
Password: meinsm

SAMSUNG Techwin
For old models
Username: admin
Password: 111111 or 1111111
For new models
Username: admin
Password: 4321
IP Address: 192.168.1.200

SONY
Username: admin
Password: admin
IP Address: 192.168.0.100

Speco
For old models:
Username: root or admin
Password: root or admin
For new models:
Username: admin
Password: 1234
IP Address: 192.168.1.7

Ubiquiti
Username: ubnt
Password: ubnt
IP Address: 192.168.1.20
Videocomm
Username: admin
Password: 12345

Vivotek
None . You can choose your own password after setup. If you want to reset it
1-Press and hold down the reset button for at least 1 minute
2-Power on the camera until the red light flashes rapidly
Now your camera is back to factory default without any password